back to the analog classifieds page
Shot Puck. the 3d printed, lead shot loaded record weight.
Note: Shot Pucks are not currently available.
Four Models: (scroll down)
Shot Puck Model One (SP1)
specs:
 | Total Wt: 234.4 grams (.517 lbs) |
| Contents: #9 lead shot (183.5 grams of shot) |
| Printed Material: ABS resin, caps and body |
| foot pads: closed cell silicone foam 2mm thick |
| spindle bushing: lathe-turned Delrin |
| Total height: 32.5mm |
| Outside Diameter: 74.7mm |
Notes: SP1 is the lightest among Shotpucks on offer. It's purpose is for turntables where a lighter weight is desirable. For instance, a suspended sub-chassis model of Thorens, AR, Ariston RD 11, etc, where the additional weight of the puck over the record might possibly have enough weight to bind the compression springs.
Shot Puck Model One rev A (SP1rev a)
Above photos: left; Cad sketch Right; The printed SP1 rev-a in textured black enamel.
specs:
| Total Wt: 326.02 grams (.72 lbs) |
| Contents: #9 lead shot (270 grams) |
| Printed Material: ABS resin, caps and body |
| Foot pads: none |
| spindle bushing: lathe-turned Delrin |
| Total height: 34.4mm |
| Outside diameter: 74.7mm |
ShotPuck SP1 rev b
SP1 rev b is a variant of SP1 rev a. The difference between the two is the "hat" on top. Otherwise it contains the same amount of #9 lead shot. All body dimensions are the same as rev a with the exception to the 'hat' geometry.
| Total weight: 340.2 g, (12 oz) (.75 lbs) |
| Net #9 lead shot weight: 270 grams |
| Printed material: ABS resin, caps and body |
| Spindle bushing : lathe-turned Delrin |
| Total height: 46.7mm (1.839 inches) |
| Outside diameter: 74.7mm |
Shot Puck Model Two (SP2) Out of stock
specs:
| Total Wt: 382.7 grams ( .84 lbs) |
| Contents: #9 lead shot (326.0 grams) |
| Printed Material: ABS resin, caps and body |
| Foot pads: None |
| Spindle bushing: lathe-turned Delrin |
| Total height: 35.2mm |
| Outside diameter: 74.7mm |